Inline FabricationWidenersReloading EverythingMidSouth Shooters Supply
Lee PrecisionTitan ReloadingLoad DataRotoMetals2
Repackbox Snyders Jerky
Page 2 of 2 FirstFirst 12
Results 21 to 24 of 24

Thread: Is this Security Six barrel salvageable?

  1. #21
    Boolit Buddy
    Join Date
    Jun 2013
    Location
    SW ND
    Posts
    324
    I have seen quite a few bad ones from the factory. That is one of the deeper ones though. If you look closely, it appears that the lands and bore are rough also. Firelapped with course abrasive?

  2. #22
    Boolit Master 243winxb's Avatar
    Join Date
    Aug 2005
    Location
    USA
    Posts
    2,844
    I used Pearl Drops to polish a Ruger that was worse then yours. It's a slightly gritty gel.

  3. #23
    Boolit Master
    Join Date
    Mar 2017
    Location
    Center Point, Texas
    Posts
    605
    Looks like it's been shot a bit already, suspect it will continue to do so. It a Security Six, not a custom bullseye gun. I'd want to throw away every gun I own if I looked it over with a bore scope. (-:}

  4. #24
    Boolit Master
    Join Date
    May 2011
    Posts
    1,077
    The gun was from a group of LE trade ins.

    The seller was very responsive and is swapping it.

Page 2 of 2 FirstFirst 12

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check