Dillon 550 press lighting

[hondo1892]

Hey guys I seen a photo somewhere of a Dillon 550 or 750 with a small led light mounted on the press. I'd like to get something like it to put on my 550 and 450 but haven't found anything yet. I don't even remember where I seen the photo now. My eyes and mind both are going.

[Valley-Shooter]

"Skylight" LED lighting Kit for the Dillon RL 550 B and C

https://inlinefabrication.com/collec...the-dillon-550

[Big Wes]

http://kmssquared.com/products.html

[tomj44]

http://kmssquared.com/ufo550.html

[Nueces]

I use the Inline Fab SkyLight and it's bright enough to check powder charges in small cases. You can move it between presses, too.

[hondo1892]

Thanks guys.

[david s]

I use one that looks like the INLINE model but it has no markings on it anywhere. It mounts in the tool heads center hole and lights the shell plate well.

[jmorris]

+1 on the KNS^2 UFO light.

[Minerat]

Inline is a banner sponsor so you only have to click in their ad at the top of the page. (Shameless promotion of a proud Cast Boolits supporters.)

[John Wayne]

I bought 4 stick on led's and the transformer from Oznium long before Inline and others offered specific kits for Dillon. I think this is much cheaper and works great. PM me and I can text pictures to you. Here is their link https://www.oznium.com/car-motorcycl...ed-light-bulbs

[John Wayne]

And just fyi for everyone I use this 10 watt from Oznium mounted on the post for the brass case feeder on the Dillon 1050. $24.95 plus one 12 volt ac adapter which can run all your loading machines as long as you don't plug in more than about 3 at a time. Link
https://www.oznium.com/led-flood-and...-led-spotlight

[Kokeman]

I used some T10 led light bulbs and sockets I got from Amazon. I cut the end off some old 12v DC power adapters I had laying around from old electronics. I was able to make 6 of them for less than $15.