Inline FabricationRepackboxRotoMetals2Load Data
WidenersLee PrecisionSnyders JerkyReloading Everything
Titan Reloading MidSouth Shooters Supply
Page 2 of 2 FirstFirst 12
Results 21 to 22 of 22

Thread: What caused this ?

  1. 03-13-2021, 10:47 PM #21
    Jniedbalski
    Jniedbalski is offline
    Boolit Master
    Join Date
    Mar 2016
    Location
    SE MISSOURI
    Posts
    969
    I use dawn and hot water with a old tooth brush. Works good. Also the heat cycling does help a lot. Some of my 2 cavity lee molds didint need it ,casted good right from the start. My lee 6 cavity and my three NOE molds all needed heat cycled. 2 to three cycles then they casted good.
    Reply With Quote Reply With Quote
  2. 03-14-2021, 03:29 AM #22
    Conditor22
    Conditor22 is offline
    Banned
    Join Date
    Dec 2018
    Posts
    3,409
    the mold cavities look good, your next casting session should go much better with this mold

    we need pictures of that too
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check