Just how deep should one mill out ar15 80% receivers. some web sites say 1.22 ?
Just how deep should one mill out ar15 80% receivers. some web sites say 1.22 ?
I try for 1.25" on the deepest section, and.650" on the shelf. I have some commercial lowers that are almost .010" deeper.
Download Ray Vinn's book, it has all the measurements in there. I've finished quite a few 80% lowers and it's never let me down.
Bob
When I brought search up the pdf was right there. Just type in Ray Vinn 80% lower and it should come up.
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |