Does anyone else make a power cannelure or grooving machine similar to Corbin's PCM-2?
http://www.corbins.com/pcm-2.htm
Does anyone else make a power cannelure or grooving machine similar to Corbin's PCM-2?
http://www.corbins.com/pcm-2.htm
I have the very machine and it is fantastic. Doesn't compare to anything out there. I swage big .510 bullets for Sharps and it presses a beautiful groove in .062 thick solid copper jacket. It is a great machine.
Zbench
I have to agree 100% with Zbench. I also have this machine and the high end manual tool sold on this site. If your doing 500-1000 bullets at a time this is the machine to have. I made up an adjustable guide assembly to feed in the bullets. Basically as fast as you can load the guide and push them in your done before you know it. I don't do rifle bullets and this is where it could get more expensive for the bullet holders. Everything is an investment and this one does an excellent job at a very fast rate.
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |