Hey all, just as if it were meant to be I have ended up with a complete set of 310 38/357 dies and a recently re-chambered henry in 357 max.. I am a complete noob when it comes to the 310 tools, but I think I can figure out their operation just fine. That leads to my issue, does anyone here know that if due to the case length between a Mag and a Max case, (.3 or so) if that would require the use of a large handle set or a short one? in other words is there enough adjustment on the small handles to use them for the longer case. Haven't been able to find much on this specific subject/question so yes I searched, would appreciate if any of you long time 310 users might know the answer. Would need to pick up a set of handles to use, and due to their apparent scarcity and discontinued-ness, want to grab the right set the first time.
Cheers