Good day everyone. Looking for some knowledge with swaging polymer tips into a core seated and pointed jackets with either a polymer bullet ball. Dave Corbin or a airsoft. My seeking of the knowledge question is how do they point up the polymer to a point like Amax bullets are done. One would suspect heat but just not sure. Also if polymer is a piece formed, do they place in center of core before it’s closed or do they just epoxy it in and close it up. I’ve been missing 3-5 years here had a TBI. I told neurologist nothing is wrong, he said your brain matter says other wise, I said no it’s lying. He said well you’ll find stuff you used to know is fuzzy with details so go back and relearn. Anyways I’m relearning. Got a set of Richard’s dies in the mail 22lr to .224 and I looked at them and said here comes the fuzzies. What did I use to do with these? That part stinks of rotten eggs. I’ve got a cnc mill Tormach broken down and I’ve got to figure out what to do with it, I used to make Fish bait molds, should of made bullet molds. I’ve forgotten it. So TBI’s are real. Regardless of impact. Story here is, my sentence may not make sense but somehow they make sense to me, any help is a wonderful thing.