So, I've got a bunch of greasy boolits now. What do you guys do to finish them off? Clean them in alcohol? Leave them lubed up? Do you guys like to run them through a tumbler to shine them up?
So, I've got a bunch of greasy boolits now. What do you guys do to finish them off? Clean them in alcohol? Leave them lubed up? Do you guys like to run them through a tumbler to shine them up?
I use dawn dish soap to degrease then wet tumble in my STM tumbler. They shine like gold.
I put them in a tee shirt, knead them for about a minute to rub off the lube.
I tumble finished swaged bullets in 20-40 grit corn cob to remove the swaging lube and give them that nice "factory shine".
Hope this helps.
Fred
After a shooting spree, they always want to take the guns away from the people who didn't do it. - William S. Burroughs.
I think I'll do a combination of all your suggestions. The hulls I'm using weren't the best looking to begin with. I don't like to waste stuff. The hollow points are pretty small so I don't think I'll get a lot of media stuck in them.
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |