Dram Worx Pyrex Powder Measure Reservoirs

[beezapilot]

My old Redding powder measure had turned a bit sour, the reservoir was badly discolored and had become pliable to the point that the two set screws were not enough to hold it in. A few rounds of masking tape held for a while, but ... so bit the bullet and ordered in DramWorx reservoirs. Certainly not cheap, but are just lovely. Got on for my old 55 and the Redding. Installation took about 3 minutes for the pair of them. Non-reactive to powder, clear as a bell, built in baffle, nice tight seal (top and bottom) with "O" rings. Took a bit of the fuss out of managing powder.

Attachment 273942

[GARD72977]

Very nice looking. I didn't know these were avalible

[wbbh]

I've got Dram Worx replacement hoppers on my RCBS Chargemaster, RCBS Lil Dandy and a Dillon powder dispenser. Excellent quality, fewer static charge headaches and they look great. They also have more capacity and are made in the USA.

[Walks]

How did you get the plastic hopper off your #55 ?
Mine won't come loose. Apparently Glued in.

[beezapilot]

Mine was just threaded on- unscrewed with a bit o force, light condensation rust on the threads had formed over the years.

How did you get the plastic hopper off your #55 ?
Mine won't come loose. Apparently Glued in.

[GARD72977]

I've got Dram Worx replacement hoppers on my RCBS Chargemaster, RCBS Lil Dandy and a Dillon powder dispenser. Excellent quality, fewer static charge headaches and they look great. They also have more capacity and are made in the USA.

I'm having static issues. Guess I need to look at getting a couple of these....

[dangitgriff]

I would like a dedicated powder measure set-up like that, who makes the best manual measure I could pair up with this hopper? And where is the best place to purchase it online?

[monadnock#5]

I'm having static issues. Guess I need to look at getting a couple of these....

There are cans of aerosol anti static sprays you can buy at the supermarket. Dust it onto the outside surfaces of the powder measure, doesn't take much. Without it I wouldn't be able to reload in the winter.

[wbbh]

I'm having static issues. Guess I need to look at getting a couple of these....

They will not eliminate all static problems. I find wiping the hopper down with a dryer sheet helps a lot.

[jeepyj]

Nice looking, marking as a reference

[fa38]

https://dramworx.com/