EndoMag 9mm PMAG 30 Magazine Conversion Adapter

[brstevns]

Has anyone tried these mags in the ar15 9mm conversions? How did they work for you?

[Wheelgun]

Yes I have 3 of them, they work excellent. I’ve probably run 200-300rds through each one, never an issue. I’ve left them loaded for months and they still have good stiff springs and feed excellent. I really like them, so much I just ordered 3 more.

[brstevns]

Must be more than 1 member that has tried these

[Cottonpicker]

I agree with Wheelgun. I have 4. Probably 300 rds. through one and no issues. I would recommend them for someone not wanting a dedicated lower. The only drawback I see is the ejector is made of polymer plastic; but with 300 rds. through it, it shows only minimal wear.

[merlin101]

I also have three of them and would buy more but they are a bit pricy, but absolutely NO complainants about them or how they work.

[brstevns]

Now I just need to save to buy one.

[umwminer]

Have had 100% reliability when inserted into gen3 window P mags .
Have had near 100% UNreliability when inserted into gen2 nonwindowed P mags .
Have not had the time to figgure out why/ what the difference is.
The gen2mags all cause a nose high jam/ftf .

[brstevns]

Have had 100% reliability when inserted into gen3 window P mags .
Have had near 100% UNreliability when inserted into gen2 nonwindowed P mags .
Have not had the time to figgure out why/ what the difference is.
The gen2mags all cause a nose high jam/ftf .

The one I was looking at was complete, with it already installed in the Magazine.