Will Corbin Mfg’s “H” dies work in Richard’s Walnut hill press?
Will Corbin Mfg’s “H” dies work in Richard’s Walnut hill press?
no, you will need to go with corbin press made for H dies.
"H" dies are 1" x 12. Walnut Hill press is 7/8" x 14. You can take the bushing (1 1/2" x 12) out of the WH and have a special bushing made for the H dies.
Last edited by DDriller; 11-28-2020 at 08:46 PM.
with this adapter it will.
http://www.swagedies.com/mm5/merchan...ory_Code=SDIES
Thanks. Needed that info for sure beforr buying a used one.
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |