I bought used Magma molds from a commercial guy and my bases are getting fins on the bases.I noticed that there is a gap on the right side of the molds. They are like 2 paper stacked on each other thickness. Is there a trick to fix this problem?
I bought used Magma molds from a commercial guy and my bases are getting fins on the bases.I noticed that there is a gap on the right side of the molds. They are like 2 paper stacked on each other thickness. Is there a trick to fix this problem?
Are you using handles or a magma machine? If handles I believe that you need RCBS mold handles.
QUIS CUSTODIET IPSOS CUSTODES?
or file/grind yur current handles to allow clearance, check for burrs to file off especially around the aligning pins
No im using a mark 7. There is a space under the sprew plate.
Remove the sprue plate there may be something under it not allowing it to set flush. Magma sells new sprue plates, try a new one or the mold may be worn in the pivot area.
Last edited by Dave W.; 09-20-2020 at 09:30 PM.
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |