WTS/WTT - AR Parts, Rapine Mould, .35 Rem, Weaver K6, Pritchett Cartridges, etc.

[Jkrem]

Looking to sell/trade the following:

1. UTG A2 stock kit complete, new unused without box. This frankly fits and feels better than an FN A2 stock that I bought, but I’m going with the FN because of the lighter color. $50 shipped/trade
2. AR Parts lot - Really nice M4 Carbine handguard set with heat shields, gas port front sight platform with pins and complete front sight, AR15/M16 flash hider (Colt?), milspec trigger guard, M4 carbine stock lock plates (2), A2 grip with screw and lock washer, probably a few other AR parts. $25 shipped/trade. SOLD M.CHALMERS
3. .35 Remington 50x brass and bullets, bullets are 200gr RNSP pulled from factory Remington ammo or new Hornady. Brass is unfired Remington, and probably once fired Winchester or Federal. $25 shipped/trade. SPF 94DOUG
4. Weaver K6 60-B, El Paso, TX. Finish is kind of splotchy, but optics are crystal clear with standard fine cross hairs reticle. $45 shipped/trade SOLD TIMSPAWN
5. 21x .550 Pritchett bullet Enfield paper cartridges by Brett Gibbons at Papercartridges.com. These are exquisitely made, and almost too nice to shoot. Brett has been deployed, and these won’t be available again until he returns from overseas. Note these don’t include powder, just the paper patched bullets and cartridges. $29 shipped/trade. SPF fgd135
6. Rapine 575461 minie ball mold, drops at .575 and weighs 523 grains with what I think is dead Soft lead. Well used, but casts nice Boolits. $50 shipped/trade. SOLD SVEN205

Items that I need for trades:

Lee .223 Remington die set - Used
RCBS Small Primer Pocket Swager Die Kit
Vietnam/1970s Era 20 Round AR/M16 magazine
M1916 leather Holster for a 1911 in good usable condition
A2 carry handle rear sight USGI, or quality after market rear sight
1911a1/Series 70 standard ejector with pin
Wilson Combat govt size magazine
1911a1 rear sight

Please pm any questions. Jkrem

[94Doug]

I'll take #3, the 35 Rem Lot. I may have a stripped handle, not sure.

Doug

[m.chalmers]

I'll buy this:
2. AR Parts lot at $25 shipped.

PM sent

[Jkrem]

#2 SPF m.chalmers
#3 SPF 94doug

[timspawn]

4. Weaver K6 60-B, El Paso, TX. Finish is kind of splotchy, but optics are crystal clear with standard fine cross hairs reticle. $45 shipped/trade

I'll take this as long as the adjustments work.

[Jkrem]

#4 SPF to timspawn

[Sven205]

pm sent #6

[Jkrem]

#6 SPF sven205

[Jkrem]

#2,4, and 6 SOLD and shipped. #3 SPF.

#1 and #5 available. Also, if you have any of my needed items please PM me! Thanks. Jim

[Jkrem]

Saturday bump up.

[fgd135]

Hey, I'll take those Pritchetts, #5. Thanks!

[Jkrem]

#5 sold pending funds to fgd135. Thanks

[Bubba w/a 45/70]

I have a carry handle A2 style rear sight, if you would like to work a trade deal on the A2 stock....I assume that complete means tube, spring, and buffer....correct?

PM me.

[Jkrem]

I have a carry handle A2 style rear sight, if you would like to work a trade deal on the A2 stock....I assume that complete means tube, spring, and buffer....correct?

PM me.

PM sent

[Tripplebeards]

I’ll second the #3 35 Rem

[Jkrem]

Please close.