I have a few MP molds for sale. Prices do not include shipping.
#1
359 Hammer HP, 4 cavity, GC, top punch, comes with large and small HP pins, penta, cup, and solid. I used this mold for one casting session.
$95 SOLD
#2
41 Hammer HP, GC, 4 cavity, comes with top punch, large and small HP, penta, cup, and solid pins. This mold has been heat cycled but never casted. The sprue plate pivot bolt has rusted sitting in my shop, but that doesnt affect the casted boolits.
$100 SOLD
#3
MP H&G 503 clone, 2 cavity, plain base, HP, this is a great SWC for 44spl and 44mag, very accurate boolit and great for target and hunting. Comes with large and small HP, penta, and solid pins, and top punch. The pentas weigh about 245gr and the solids weigh about 265gr. Great long range boolit too!
$70 SOLD
#4
MP 432-256 (marked on the mold), 4 cavity solid, plain base. This is the same as the H&G 503, another clone. Minor rust on the top side of the sprue plate. Excellent boolit for 44 magnum and 44spl. I have pushed this boolit past 1400fps in the 44 magnum with great accuracy.
$75. SOLD PENDING FUNDS
#5
MP 454-297 as marked on the mold, solid, 4 cavity, plain base. This is the same as (and is) the 45 Ruger ONLY boolit. This is a LFN design in my opinion.They drop around 330gr and are very accurate and excellent long range boolit. The OAL of a loaded cartridge is 1.725” so check your cylinder length.
$75
Prices dont include shipping. I plan to ship using flat rate boxes. “Ill take it” trumps all inquires.
All the molds listed are brass molds.
I dont take PayPal on principal....I prefer USPS money orders, thank you
ALL MOLDS ARE SOLD AND SENT