RepackboxMidSouth Shooters SupplyReloading EverythingWideners
Inline FabricationTitan ReloadingLoad DataLee Precision
RotoMetals2 Snyders Jerky
Results 1 to 3 of 3

Thread: MP 356-130 2R 8 Cavity Mold

  1. 09-04-2020, 02:26 PM #1
    o416
    o416 is offline
    Boolit Buddy
    Join Date
    Aug 2020
    Posts
    227

    MP 356-130 2R 8 Cavity Mold

    Hi Guys!

    Anybody have this mold? Would you mind sharing some of your cast bullets? What do you think about this mold? Any tips?

    It is the bevel base, no lube groove, design made from aluminum.

    Thx!
    Reply With Quote Reply With Quote
  2. 09-04-2020, 03:55 PM #2
    Drew P
    Drew P is offline
    Boolit Master Drew P's Avatar
    Join Date
    Nov 2015
    Location
    NW USA
    Posts
    1,164
    I have it. It’s nice but I prefer the 135gr flat point mold he offers. The bevel base rn one is a little fat right around the case mouth where the flat point steps down a few mil.
    Reply With Quote Reply With Quote
  3. 09-05-2020, 12:17 AM #3
    tomme boy
    tomme boy is offline
    Banned

    tomme boy's Avatar
    Join Date
    May 2011
    Location
    Clinton, Iowa
    Posts
    5,200
    Any of his 2r molds are going to have problems with the throat. You will have to seat deeper than normal.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check