looking for a 9mm HP mold

[HVACscott]

is there a supplier that has a 9mm, HP, around 115 gr, prefer 4 cavity mold in stock?
looked at MP, Lyman, lee, NOE...
did i miss a manufacturer that makes a decent mold

[Hutch556]

This is a great HP mold. It’s a little heavier than 115, but it is in Stock.

https://www.mp-molds.com/product/mp-...o-lube-groove/

[HVACscott]

This is a great HP mold. It’s a little heavier than 115, but it is in Stock.

https://www.mp-molds.com/product/mp-...o-lube-groove/

how the heck did i miss that
thank you, thank you, thank you, thank you

[Hutch556]

how the heck did i miss that
thank you, thank you, thank you, thank you

No problem, they also have the lube groove version in Stock as well.
https://www.mp-molds.com/product/mp-...5-hp-pb-4-cav/

[HVACscott]

No problem, they also have the lube groove version in Stock as well.
https://www.mp-molds.com/product/mp-...5-hp-pb-4-cav/

thanks i think i stopped at .358 but i think .359 and resize will work

[Hutch556]

thanks i think i stopped at .358 but i think .359 and resize will work

Yes, will size down just fine. That Mould is or at least in the running for the one to beat for HP 9mm molds in my opinion.

[HVACscott]

can i resize from .359 to .356... and should i do it before and after Powder coat or will it work just after PC

[Hutch556]

can i resize from .359 to .356... and should i do it before and after Powder coat or will it work just after PC

Yes, you can do it after powder coat. Sizing down to .356 Will be just fine. Use a little spray lube if it is tuff to size down.

[HVACscott]

thanks

[Hutch556]

Also, for whatever it’s worth of the two molds they both are great, but I prefer the one with the lube groove. If you ever run out of powder coat you still have an option to lube traditionally and also I believe the lube grooves when sizing down gives a place for lead to move. With that said either will be great though.