ok...........lets see if i get this close youins can add tips or suggestions to accomplish each feat. not necessarily in correct order, as i'm a dummy....remember?
(1)first......search for wheelweights to melt down.
(2) start collecting tools for the job. a lil pot(not fer smokin), a ladle, a heat source, and some bullet lube???
(3) slug the bore in some manner to get correct bullet size. any tips for a way to do this?.....or is it necessary? do ya then need to buy a bullet sizer or stuff to do that with?
(4) melt lead, put in a lil wax(how much?) to skim off nasties, and pour into bullet mold or ingot mold. is it necessary or how desirable is it to melt the lead and form into ingots?
(5) size the bullets. what is required to do this, and what is the least expensive route? can it be done with a regular loading press, or is it even necessary to get good accuracy?
(6) shoot em up n test for accuracy. anything in particular to look for as far as the cast bullets go?........as in seeing something you had done wrong?
yep........i'm a dummy. i gotta be lead around like a ol mule. a step by step procedure in hillbilly terms is what i'm lookin fer, i reckon.