I mark mine with a sharpie, but spray paint sounds like a good idea.
I move my lead around in black buckets designed for cement work. They are meant to take more weight than normal plastic ones.
Watch your back! You only have one.
I now just use the Castboolits moulds from Lakehouse and stamp them next to the cast in markings. I don't plan on moving them anytme soon, but if i did I could technically just dump them all in my pickup bed and re-sort them when I arrived at the new place. I like to find old metal boxes to store them in, like larger tool boxes, as they don't ever break down and dump my ingots on the floor.
I moved from Jersey to West Virginia. Have about 2,000 lbs in corn bread ingots ( they will be recast into ingots) and used the stamps to mark them like NY Firefighter does. Word of caution. I used PODS. Will never use them again. The unit must have had a weak floor near edges as they busted through the floor with their fork trucks. New it was bad when they dropped it off and guy says you reload, huh. He hands me piles of my ingots that had fallen through the holes they made breaking the buckets they were in and loose stacked near walls. Not fun. Good luck.
I'm curious. How do you access the ingots? Do you always work out of the top box? My boxes(not as nice as yours), hold 100 lbs and I can only lift them to move them a very short distance. Granted, my age enters into that, but I think that 150-200 lbs would be beyond all except accomplished weight lifters.
John
W.TN
I hope that is a well supported floor!
John
W.TN
I use 5 gallon buckets with a drain hole in them if outside. Inside they are just as is unless you over fill them. Lat two moves were around a ton. Get a ramp and a good handtruck and it goes fairly easily.
[The Montana Gianni] Front sight and squeeze
In those stacks of crates I'm seeing an excuse to get a front end set of forks for a small Kabuto, and the tractor if one isn't already on premises.
I can do a 50 cal. box of loaded ammo but a 30 caliber for cast boolits is a lot easier to manage. Would rather have two 30 caliber with labels like .38 #1 and .38 #2 so I can eventually recall what bullets for 38/357 are in which numbered box.
Milk crates don't waste as much space if you do this simple trick. Stack them 3 high loaded 1/3 of the way full with lead. Wait a few months. Then remove the top two crates which have blown through the bottom allowing the lead to all fall through to the bottom crate. Don't ask how I discovered this little space saving trick. I think plywood insert is pretty mandatory for milk crates.
Scrap.... because all the really pithy and emphatic four letter words were taken and we had to describe this source of casting material somehow so we added an "S" to what non casters and wives call what we collect.
Kind of hard to claim to love America while one is hating half the Americans that disagree with you. One nation indivisible requires work.
Feedback page http://castboolits.gunloads.com/show...light=RogerDat
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |