Probably just the filter cap. Replace any that have bulged top. If coil has continuity it's still good assuming you can solder back in. Those boards have 1 mil or less copper and any heat will destroy the board material. I wound a small section of fine bare wire around the lead and soldered down to exposed copper. Didn't help the oven I worked on, display was bad anyway.
Whatever!
We have only two shops that carry electronic parts.
One is almost never open.
The other didn't have it.
I should have known that.
I'm thinking if I have to order it, would not be worth it.
Might end up just trashing it.
Posting Permissions
| BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
| BR | Bench Rest | M | Magnum | RN | Round Nose |
| BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
| C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
| HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
| PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
| LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
| GC | Gas Check |
Reply With Quote