Finally had a chance to run this bullet through my 308. Rem 700P.
Only tested at 50 today. I’ll stretch it out next time out.
Ran 95/2/2 heat treated to around 24 for the IMR 3031 loads. Did a work up with 3031 from 22-28 grains. Best average groups were with 27 grains.
Ran same alloy not heat treated for the IMR 4198 and Unique loads. Zero work up or load dev on those two. Probably gains to be made if I put some time into them.
Two 3 shot groups per plate. No big whoop but first time with cast through this gun so I’m pleased.
That looks like some big whoop to me. I think you're onto something.
Sent from my SAMSUNG-SM-G930A using Tapatalk
I too have had good results with the Forester hollow pointer. Probably your best bet for expansion. Air cooled 50/50 will flatten a little with a flat sizing punch.
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |