RotoMetals2RepackboxInline FabricationLee Precision
Titan ReloadingWidenersADvertise hereMidSouth Shooters Supply

Results 1 to 1 of 1

Thread: MP 165 grain 40 caliber mold

  1. #1
    Boolit Buddy
    Join Date
    Jan 2013
    Location
    Beattie, TX
    Posts
    121

    MP 165 grain 40 caliber mold

    I have seen little posted about results with this mold and since I'm temporarily shelving my attempts to shoot cast in my 9mm, it is time to move on.

    I've found this brass mold - my first - to be very tempermental at lower temps and the higher I raised my pot temp, the better it performed. Casting between 800 and 820 degrees provided the best boolits and I could never cast fast enough to get frosting. Alloy is 50/50 COWW/PB/2% SN, ice-water dropped after coating. I intend to shoot these in both .40 and 10mm, primarily for bullseye matches. These were powder coated yesterday with the hopes of shooting some today. .40 will be first as the press is set up for small primers.

    If anyone else has some experience with this boolit, I'd sure like to hear about it.

    [IMG][/IMG]
    Last edited by mvintx; 06-01-2020 at 02:27 PM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check