WTS 452488 mold, 30 cal mold, 9.3 dies and Dillon plate for sale. Clean up/out sale!

[Zingger]

Over the winter I have branched out on some of the reloading and casting- these are components that I don't/won't use.

As always- these prices are shipping included. The first to publicly post that they'll take item ___ for ____ and send me a pm with the particulars is the new owner of the item.

Payment terms: Check or USPS MO, cash if you trust the usps.

#1 Lyman 452 488 4 cavity mold. It does not have the handle screws. Works well, I prefer my other 2 cavity- SPF to lost6gunner.


#2 Dillon 550 plate #7 for the 30-30 and 32 WS. $30 shipped.Now $25Final Reduction to $20 shippedspf to Marcus p323


#3 keeping for now.

#4 Ideal set 311413 Single cavity with handles. Sold/shipped to Adcoch1


Thank you for looking at my ad- feel free to ask any questions!

[Valley-Shooter]

Zingger, your in box is full.

I'm only looking for bevel base 130.

Sent from my Pixel 4 XL using Tapatalk

[adcoch1]

#4 311413 for $40 shipped, I'll take it. Pm incoming.

[Andy45]

PM sent on #1

[Zingger]

bump up.

[Zingger]

Bump for reduced prices- time to send this stuff to new homes!

[Zingger]

Bump please

[marcusp323]

I'll take the #7 plate please
Mark

[Zingger]

Still some great deals- If I didn't have 2 other molds in 45 cal I would probably keep this one. Feeds fine in 1911's and the CZ97. Works in revolvers as well. Make offer if price is too high.

[Zingger]

Let's put it up top one more time. Don't be afraid to offer a trade on the mold! I like 30 cals (heavier), a 9.3 mold would be great as well.

[Tim357]

Not for nothing, but as a PSA, the 488 mould will feed well and allow proper ejection of fired brass in Glock pistols

[Zingger]

Thank you Tim- I didn't know that- I will keep it up for a few more days then throw it back into the drawer.

[kbstenberg]

Zinger is there a problem with the 452488 mold? I am looking at the area around the alignment pins. Looking like it has been worked on.

[Zingger]

Hello neighbor- I am holding the mold right now. Lockup is good, maybe they opened the alignment holes a bit, comes apart easily. The sprue plate I am not crazy about, it seems loose but is workable. I have used the mold myself, I have another 200 grainer that I like quite a bit. With one groove for lube it sized well, but having to change the settings on the dillon for one type of bullet was too much of a pain. It shot very well in the molds defense. Let me know if I can answer any other questions and thank you for reaching out.
Zingger

[Zingger]

Lock it please. All sold!