Wtb - small amount of 45 gas checks

[Rp-]

Any chance anyone would part with a small amount? I don't need a whole box of 1000 and even half of that would be more than I'd need. So anyone have just a couple hundred laying around? Or anyone have a gas check maker they would rent me for a week?

Sent from my LM-G820 using Tapatalk

[RedlegEd]

Any chance anyone would part with a small amount? I don't need a whole box of 1000 and even half of that would be more than I'd need. So anyone have just a couple hundred laying around? Or anyone have a gas check maker they would rent me for a week?

Sent from my LM-G820 using Tapatalk

Hi,
Would that be .45 Rifle or pistol? If rifle, I can help you out.
Ed

[Rp-]

I didn't know there was a difference. I would assume rifle but planning to size to 452 and powder coat after gc. I have a Lee 454-300 mold and I'm planning to use it for 454, 460 s&w, and 450 bushmaster.

I guess I was under the impression that they would work for either pistol or rifle.

Sent from my LM-G820 using Tapatalk

[RedlegEd]

Hi,
Yep, there's a difference. Have a look here at Sage's Outdoors (where I normally buy mine.) The GC shank for both sizes is normally about 0.424-0.427", but I believe the difference is in the thickness of the check material. I have the Gator GC in .458. I can mail you a few just to try and see if they work. They might be a little harder to size, but I don't think they would deform. If you're interested, PM me your address.
Ed

[wallacem]

Are you looking for a check to go on plain base bullets or bullets made for gas checks? Wallace

[weakhand luke]

Cu or Al?

[Rp-]

Don't know about cu or al. Don't know really anything about gas checks. I'm assuming 452 and 458 would use different checks then?


Using these on a Lee 454gc bullet. Planning on 1400-2000fps used in 454 casull, 460s&w magnum, and 450 bushmaster.

Sent from my LM-G820 using Tapatalk