Anybody printing the Hex Wrench Holder for a Dillon 650?
|
   
   
|
|
Anybody printing the Hex Wrench Holder for a Dillon 650?
Why not A) buy the Dillon one, or B) take a piece of aluminum and make your own? I have the Dillon one on my 650 and it’s very nice but wouldn’t be terribly hard to replicate I wouldn’t think.
I'll take your questions in reverse order: B) I don't have any Aluminum, Steel, ect to fab one myself; And A) Dillon doesn't sell one by itself, It'd be approx $40 to buy the set. Additionally, I figured there would be a few 3 D Printer folks on this site that would like to make a buck. Thinkiverse has plans, at least for the 550.
Might also check your local library than. I know our local library just added a 4th 3D printer space if you already have the plans than might be able to go that route?
Last edited by StuBach; 03-21-2020 at 10:00 PM.
I don't have a 3D Printer, otherwise prob solved. Thanks for the suggestion(s).
Found what I was looking for over on the Bay. $18 shipped. Sweet!!
Close.
Posting Permissions
| BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
| BR | Bench Rest | M | Magnum | RN | Round Nose |
| BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
| C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
| HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
| PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
| LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
| GC | Gas Check |
