want to sell uncommon .41 mag molds

[GLynn41]

First post gets them if any one wants one
Want money order/ cashiers checks plus actual shipping and insurance if desired.
A. Lyman 410459 2 cav from the 70's $50.00
B. Saeco .411 230 gr Keith 4 cav $90.00
C. Mountain Mold 255 gc WLN.. .33 meplat brass mold 70.00

All are very good casters. all have been used to take deer or boar... not that matters )
I will give this a couple of days then will take it down
Glynn41

[megasupermagnum]

Can I see pictures of the Saeco .411 230 gr Keith 4 cav? I may be interested.

[doghawg]

How about pictures of 410459?

[mattw]

Square or round grooves on the lyma?

[bushog]

I'll take the Saeco mold!

PM sent...

[firebyprolong]

I'll take the Lyman 410459. PM on the way.

[TheGrimReaper]

I am really interested in
C. Mountain Mold 255 gc WLN.. .33 meplat brass mold 70.00

Could I please see a picture of it
You can post or pm me please.

[TheGrimReaper]

Also
How many cavity?

[GLynn41]

The Lyman is gone.
The Mountain mold has a pm about it.. it is a two cav brass
as does the four cav saeco
megasupermagnum said I can send pixs to him which I will do in a while... thanks to all

[bushog]

I want the Saeco mold!

I PM'd you but no response?

[GLynn41]

Bushhog I am awaiting an answer from some one who was a few minutes a head of you... will let you know-sorry for the delay
The Lyman 410459 is gone, only the Mountain Mold is left as far as I know. If you pc you might --might not need a gc for it

[Chad5005]

can you send a pic of the mountain mold,229-310-7669

[bushog]

Thanks....let me know...

[megasupermagnum]

Bushhog I am awaiting an answer from some one who was a few minutes a head of you... will let you know-sorry for the delay
The Lyman 410459 is gone, only the Mountain Mold is left as far as I know. If you pc you might --might not need a gc for it

I have not seen pictures on here or by email yet. Please resend.

[GLynn41]

I will try -- only mt mold is left
You can go to MT Mold and put in the spec and see what it is
as cast .411, .400 nose.. 80% meplat, tangential, cut for .416 gcs… has a small lip for the check to crimp on, single lube groove

[megasupermagnum]

I will try -- only mt mold is left
You can go to MT Mold and put in the spec and see what it is
as cast .411, .400 nose.. 80% meplat, tangential, cut for .416 gcs… has a small lip for the check to crimp on, single lube groove

could you take a picture and send it to my phone?

[megasupermagnum]

Here is the mountain mold 255 grain. Apparently he sold the Saeco.