haven't been able to contact noe to place a order; so, i will make my own sizing die push rods. but, i have a question. for those of you that have the push rods for the various calibers; what is the diameter of 6.5 mm, 7 mm and 30 cal. push rods??
|
   
   
|
|
haven't been able to contact noe to place a order; so, i will make my own sizing die push rods. but, i have a question. for those of you that have the push rods for the various calibers; what is the diameter of 6.5 mm, 7 mm and 30 cal. push rods??
If I was making my own , I would make them 4-5 thousands smaller than the smallest die that they were used with. I have many & they are loose in a box & I grab what looks close & just make sure it fits through. You can always make smaller. I probably end up using a 6.5 in a .284 so times with no problem , but I’m sure closer fit is better.
Just measured my .30cal Lee and NOE push rods. Both are .304. My body size dies are .309 and .310.
Posting Permissions
| BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
| BR | Bench Rest | M | Magnum | RN | Round Nose |
| BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
| C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
| HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
| PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
| LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
| GC | Gas Check |
Reply With Quote