I have just finished forming 500 360 Dan Wesson cases into 256 Winchester. The first thing I did was anneal the case mouths with a Ballistic Edge annealer. They were then run into a 30 Mauser fl die to neck to 30 cal & move the shoulder most of the way back. Next they were sized in an RCBS 256 Win fl sizing die to neck down to 25 cal & move the shoulder to its final position. They were then trimmed to 1.281 & flash holes were deburred. Now comes the question I need opinions on. Should I anneal the case mouths again or just load and shoot? Inquiring minds need to know.
Bob