WTS Hard lead

[Kylongrifle32]

Lead alloy 95% lead 5% antimony poured into "Cast Boolits" and "Redneck Gold" ingots from lakehouse2012.

Small flat rate box at 24+ pounds per box.
$30 dollars per box shipped to US. Payment of USPS money order or personal check with wait till cleared.

10 boxes available. Please post "I will take" followed by a PM for payment info.

1)spf djryan
2)spf dyryan
3)spf djryan
4)spf mjdd23
5)spf mjdd23
6)spf gard72977
7)spf psychodad
8)spf superdan
9)spf superdan
10)spf superdan


Thanks Mike

[bazzer485]

Why no tin ?
Barry


Sent from my iPhone using Tapatalk Pro

[djryan13]

I will take 3 please. Check to be sent.

[Mjdd23]

I shall take 2 boxes please.
Sending PM. Thanks.
Mark

[Kylongrifle32]

Barry.
This is just how I get the source of lead. I lucked into this after my 20 year old supply of good quality wheel weights got to a critical level. For my plinking and just general target shooting in both handguns and rifles this lead has worked out just fine. I'm a low tech kind of guy and since I have no issues with the lead I just send it down range as poured and save my supply of WW for hunting boolits. So far it has worked in all my molds from 7mm and up. The only issue I have from the lack of Tin is when trying to pour 70-80 grain .22 Cal boolits I have to run the pot and molds hotter than usual to get proper mold fill.

[GARD72977]

I will be take one.
Thanks Larry

[psychodad]

I'll take one. PM inbound.
Thanks
Jim

[Master Samwise]

I'll take one. PM inbound.
Thanks
Samwise

[superdan]

Pm sent on the last 3

[bedbugbilly]

I'll take a box if Superman doesn't take the rest. Thanks.

[bazzer485]

Thanks for the info. If I can get a Mould I would like to try casting some 22 air rifle pellets.
Cheers
Barry


Sent from my iPhone using Tapatalk Pro

[Kylongrifle32]

That would probably require pure lead for that task.
NOE has air rifle molds.

[bazzer485]

That would probably require pure lead for that task.
NOE has air rifle molds.

I think the lead will need tin to mould better. My casting has improved out of all proportion since I built a pid temperature/ heater controller for my casting pot
Thanks





Sent from my iPhone using Tapatalk Pro

[mtgrs737]

I bought some to make my own "Magnum Shot" for long yardage trap. I found it to make harder shot than the so called Magnum shot from any commercial shot maker. Buy with confidence!

[djohns28]

I would be interested if you could take PayPal.

[Kylongrifle32]

All boxes have been claimed

[Kylongrifle32]

All boxes shipped please close this thread