This is my first attempt in forming cases, I don’t have any sneaking equipment so I just throw these on the press mostly to see if I can do it. I started out with range picked up PMC .223 that had been deprimed and wet tumbled.
I lube the case with spray lanolin in alcohol and use a Redding .221 trim die followed by FL die on a Forster Co-Ax. I had read some of the treads here on forming 221 brass but that don’t seem to get me anywhere.
I also have a 300blk die set and 221 neck die, should I use those as intermediate steps?
Sent from my iPhone using Tapatalk