Anyone shooting cast out of a fs at steel, what mold what size any powder coating? Thanks joe
Anyone shooting cast out of a fs at steel, what mold what size any powder coating? Thanks joe
Just targets. NOE 135 grain 5.0 power pistol .358
Sent from my SM-G960U using Tapatalk
Last edited by Thumbcocker; 01-26-2020 at 10:21 AM.
Paper targets aren't your friends. They won't lie for you and they don't care if your feelings get hurt.
Thanks what lube if you dont mind?
Ben's red
Sent from my SM-G960U using Tapatalk
Paper targets aren't your friends. They won't lie for you and they don't care if your feelings get hurt.
I have an RIA Ultra FS in 9mm. Only paper targets so far. Perfect function once I began using Wilson Combat magazines.
Good accuracy with many different boolits and powders.
Lee 120 tc, Lyman 356402, Lyman 358212, NOE 135 grain flat nose, Lee 125rn. I use many different powders as I am working through a number of bottles purchased during the shortage.
They all work well.
It seems to prefer loads in the upper range for 9mm standard loads. I have not run any +P through it.
Lubes used are White Label Xlox tumble lube, WHite Label NRA 50-50, and TAC-1. No obvious differences in performance.
I don't have a load for it that shoots quite as well as jacketed yet. Still working on it but it is close. Groups are about 1 inch larger than what I get with jacketed at 12 yards.
It easily holds the ten ring on a silhouette at that distance with the large majority in the X ring.
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |