Hello:
First time post, new to reloading. I have a few questions, tried the search function but did not see the same questions, so hoping someone can offer some advice.
I'm reloading for my H&R 732 32 Long revolver. I have Lee Carbide dies, HP-38, new Starline Brass and Hornady 32 cal .314 90 Grn HBWC (product number 10028).
My Lee Modern Reloading Book (2nd edition) lists data for a 90 Grain Lead Bullet and a 98 Grain Wad Cutter, but not a 90 Grain Wad Cutter. Which load data should I use?
The bullets have a cross hatch pattern along the surface, do I need to tumble lube the bullets? I have a tube of Alox, but wasn't sure if it is necessary or the correct lube
Since the bullets are hollow based, do I need a gas check on the bottom of the bullet?
The Lee seating die appears to be for a round nose projectile. Can this be used to properly seat a wadcutter?
Should the wadcutter be seated flush withthe top of the case?
Thanks in advance for your advice!