FS - Lee Hand Priming Tool Tray Lid - Round Tray

[RedlegEd]

Hi all,
Last call before moving on to other forums.
Ed

This is an update to my previous post below. A great member on this board (Rockzilla) lent me his Lee Round Tray priming tool so I could get the measurements of the tabs on the tray. I can now print a direct replacement lid that will work with the tabs. I've posted the new design on Thingiverse (see the link below,) or I can print one for you for $5.00 with additional lids at $2.00 each (in the same shipment.)
Ed




I've used my new 3D printer to make the lid to the Lee Hand Priming Tool with the round tray, which you can't buy anymore from Lee or FS Reloading. Mine got broke, so I designed one that fits my Lee and thought there might be a few others on this site that may need one, so I'll be happy to print one up for you. If you already have a 3D printer, I've posted the files on Thingiverse. You WILL have to trim the tabs from the lower tray for this lid to fit. Cost is $5.00 mailed to your door to cover postage and filament (2 for $7.00,) PayPal F&F preferred, but I'll work with you. Send me a PM if you'd like one.
Thanks,
Ed

[RG1911]

Are yours a more snug fit than the original Lee that rattles and loosens under use?

Thank you,
Richard

[El Bango]

Sounds interesting,I'll take one,PM to follow.

[RedlegEd]

Are yours a more snug fit than the original Lee that rattles and loosens under use?

Thank you,
Richard

Hi Richard,
Mine fits on fairly tight. As I said in my OP, you WILL have to trim the tabs off the tray body for the lid to fit.
Ed

[RG1911]

PM sent.

[RedlegEd]

Bump for today. Ed

[RedlegEd]

Hi all,
Last bump before I close this move it on to another forum.
Ed

[tdoor4570]

PM sent

[psychodad]

PM sent.

[Rockzilla]

These work on all my old Round tray Autoprimes, the fit and function is great.


-Rock

[stubshaft]

I'll take one. PM sent.

[Dimner]

Do you know if anyone has designed one for the square version?

[RedlegEd]

Do you know if anyone has designed one for the square version?

Hi. I'm not aware of one. I looked on Thingiverse and didn't see it, but that doesn't mean someone hasn't created one somewhere.
Ed

[Dimner]

Hi. I'm not aware of one. I looked on Thingiverse and didn't see it, but that doesn't mean someone hasn't created one somewhere.
Ed

Okay, Appreciate you looking it up. I may end up designing one someday. Doesn't seem that hard. Thanks

[RedlegEd]

Hi all. Closing the ad so I can move it on to another forum and not violate Swappin & Sellin rules. Mods, please close thread.
Ed