just got one, anyone have a 300 B/O load for it ? im gonna PC it and use LC converted brass
just got one, anyone have a 300 B/O load for it ? im gonna PC it and use LC converted brass
Last edited by pacomdiver; 01-10-2020 at 09:53 PM.
As Hamish stated, just start on the bottom end of the closest bullet and keep in mind volume of the case with the bullet seated. Some powders will fill out the case better than others. I don't have any direct experience with that boolit but I am tagging along because I am also looking at that mold.
"Give me liberty, or give me death!" Patrick Henry ,March 23, 1775
I'm very surprised someone has'nt posted about that particular mold in the BO. The heaviest I shoot is a 200gr LGGC at a comfortable 15.7gr of Reloder 7. Have paid attention to this thread as I've been thinking of PC'ing a plain based TL309-230R in my BO's. If I liked it, was going to try the NOE.
More "This is what happened when I,,,,," and less "What would happen if I,,,,"
Last of the original Group Buy Honcho's.
"Dueling should have never been made illegal in this country. It settled lots of issues between folks."- Char-Gar
I use this bullet in 300 blk out. I believe it’s 10 gr aa1680
I use it both plain based and gas checked w 10.5 gr imr 4198
ive been using it (plain base) powder coated with 8.0 g H110 in LC cases and CCI primers. it cycles my 10.5 B/O and locks back on last round. ive been experimenting with it in 308 and Trailboss powder with some good results
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |