Don't know if this is the right place for this, so if not, put it where it belongs.
Am reloading some once-fired GI -06 ammo for a chum. Primers all crimped in, so after resizing/de-capping, I ran them through an RCBS PP swager. On re-priming w/old Lee primer putter, some primers didn't want to go in - in fact, I ruined the Lee primer putter - put so much pressure on the lever that I stripped the threads that hold the case holder! On another, the primer wouldn't go in all the way,, and so the case was locked in the shell holder. Have it soaking in Kroil to kill the primer before knocking it out. By the way - miked the Tula primers, and they measured .2105 - the Alcans measured .2101/2. And the RCBS swage measured .205 - couldn't measure the top radius, just the shank. Did manage to prime (on the RCBS press) some, after using a PP reamer to clean up the PP's, but some gave problems still, whether Alcan or Tula. ***, Over?