bought a Remlin 1894C last year intending to use it for deer on the high side and cans on the low side. Got a good 1400fps Lee 358158 load for everything but deer and bought some Cast performance 180 wfngc for deer. I push them with 13 gr H110 for 1550ish fps. I didn't buy a 180 gr mold because I don't anticipate shooting many 180 gr boolits, so I figured a box of 100 would last a while after I got a load worked up. I was able to collect a large doe Tues afternoon at about 65 yds shooting from a ground blind. I waited till she was full broadside so I could get good shot placement. There were thick planted pines close by that she was probably gonna run into and I didn't want a long tracking job in that environment if I could avoid it.I hit her right in the boiler room and got complete penetration. She ran about 50 yds and piled up dead after a run that lasted about 3 seconds. The exit hole was caliber size as I feared it would be. These boolits are heat treated. Blood leakage was minimal in fact, I never found a drop, but the boolit killed well and fast. I have mixed emotions about this. The boolit performed very well in the killing dept, but I really like a blood trail. They don't always fall in 50 yds even when well hit and had she run much farther she would have been hard to recover. I may break down and buy a mold for a similar boolit and cast my own out of softer alloy, I'll ponder it.