where can I get loading data for 220 grain cast HP bullets....
where can I get loading data for 220 grain cast HP bullets....
keep on rolling along.no matter what happens just keep rolling
I would use the data for the 429215 which while listed at 215 gr always ran heavier, IME.
[The Montana Gianni] Front sight and squeeze
You might want to work up a load for the 44mag starting with a mild load of 5gr.Red Dot.
I started out with nothing and I still have most of it left.
Paralyzed Veterans of America
Looking for a Hensly &Gibbs #258 any thing from a two cavity to a 10cavityI found a new one from a member here
7.5 to 8.5 grains of Unique . Should work as well with the 220 as it does with my Keith 429421HP and the same bullet in a solid . Might try 15.5 grains of 2400 , thats Taffin's load for the 220 gr Thompson bullet .
Grumpy Old Man With A Gun....... Do Not Touch !!
In a 44 Mag with Mag cases .....
From Hodgdon’s #26: HS6 start 10.0 gr , Max 12.0 gr , 250 gr. lead boolit psi 24,000
Newer manuals run HS6 into the mid 30k range so that 12 gr Max is not really a true max load, however I load just a wee bit off the 12 gr. listed in #26 and run my RCBS 250k cast slug at 11.8 gr.with (in my case) a Federal 155 Mag primer.
This IMO is a super good load. Easy on the paws, as a spherical powder HS6 goes through a powder measure like you know what through a tin horn and the SD and accuracy are to die for. Velocity puts it more powerful than the Skelton loads with 8.5 gr of Unique as it runs 1066 FPS out of my 4” MG (7 FPS SD) but south of 2400 performance and less recoil.
I see no reason one can’t adapt that data to run a 220 gr slug since I have run it down to 200 commercial cast myself.
Enjoy
Three44s
Last edited by Three44s; 10-27-2019 at 09:37 AM.
Quote Originally Posted by Bret4207
“There is more to this than dumping lead in a hole.”
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |