Well I took the Remlin out again yesterday and fired several boolits designs with Trail Boss, Green Dot and Unique. All boolits were sized .433, but when loaded on my Square Deal B, the crimp die must be swaging the boolit down some because the neck measurement was less than when the round came out of the seating die! Perhaps they were .432 or less? I'spose I could forego the Square Deal B crimp die, and run each round thru the Lee FCD so as to keep the original .433 dimension, but that is a step I'd rather not do. After all, I use this Square Deal B for 10 different .44 magnum revolvers from 329PD to model 69, and lots of Rugers, as well as 2 Winchester rifles and a Rossi 92, and I don't have to use the Lee FCD on them. I'm about ready to give up on getting this rifle to shoot at least 2" at 50 meters. Like Herman Cain said,
"This dog don't hunt!"