Lee PrecisionLoad DataRepackboxTitan Reloading
WidenersMidSouth Shooters SupplyReloading EverythingInline Fabrication
RotoMetals2
Results 1 to 5 of 5

Thread: Could use a 7.62x39 die set and mold

  1. #1
    Boolit Grand Master Tripplebeards's Avatar
    Join Date
    Apr 2017
    Location
    USA
    Posts
    5,514

    Could use a 7.62x39 die set and mold

    Just picked up an sks and looking for a die set. I’ll have to figure out a mold for it as well.

  2. #2
    Boolit Master
    Join Date
    Nov 2011
    Location
    Indian trail NC
    Posts
    784
    lee makes both for it

  3. #3
    Boolit Grand Master GhostHawk's Avatar
    Join Date
    Mar 2014
    Location
    Fargo ND
    Posts
    7,075
    Look at the ads at the top of the page. Either Titan or Midsouth will have dies, molds, gas checks. (If your going to go faster than 1400 fps I recomend a mold with a gas check)

    Personally my Yugo likes the Lee .312 185 with gas check with modest amounts of IMR 4895. Soft shooting, accurate, cycles the action.

    Now I can make very similar loads with Red Dot, but it won't cycle the action. Turns it into a straight pull bolt action. Which for keeping your good boxer primed brass is not all bad.

    28 grains of 4895 will get you 250 loads per pound.
    4.6 grains of Red Dot will get you over 1500 loads per pound.

    Just for cost comparison. And yes, I like Red Dot/Promo, works in everything. Just does not always cycle the action.

  4. #4
    Boolit Buddy xbeeman412's Avatar
    Join Date
    Sep 2010
    Location
    Texas
    Posts
    268
    I will donate a lee set of dies to U. may be slow shipping out due to mu health. Just pay 8.00 for shipping and they are yours. Paypal address is xbeeman412@aol.com

    My address is
    Charles Steen
    14603 oleo
    santa fe tx 77517
    God Bless
    Stay Safe

    Charles Steen

  5. #5
    Boolit Grand Master Tripplebeards's Avatar
    Join Date
    Apr 2017
    Location
    USA
    Posts
    5,514
    Thank you!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check