I fastened mine to an oak 1x4 about 5 inches long. I use a c-clamp to attach it to my bench. Works great.
NRA Benefactor Member NRA Golden Eagle
There are several ways to go with this. If you only have a modern stand with 7/8 14 threads buy a 3/4 inch bolt 2 washers and a nut. Bolt this thru a piece of wood mounted to measure. The 3/4" bolt should slide thru the hole in measure and the nut used to lock it in place. quick and easy. Another is to make a stand just for this measure than can be clamped onto the bench with a c clamp or 2. This is nice also and made right with a good base it can sit on a shelf out of the way when not in use. A piece of 1X6X10 for the base a 1x4X10-12 for the stand and 1x4x6 for the top. Here hard wood looks nice and gives mire stability, A piece of 1-1/2" dowel rod can also be used for the upright beam. Glue and dowel the joints in this stand for added strength. Last is install 2 studs in a shelf face on location ( wood screw on one side and machine screw other) then use wing nuts and washers t hold it when in use. Those are probably #10 (,187 dia) or 1/4" holes.
Put some screws in a 2x4 and clamp or screw that to a loading bench
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |