Looking for CB loads using Unique in 357 Sig and 40 S&W

[LRRifleman]

Hello! Sadly, my cast bullet loading manuals pre-date the creation of the 357 Sig and 40 S&W cartridges. I am looking to use Unique with the following bullet/cartridge combinations:

9 mm - Lyman 356402 124gr truncated cone
9 mm - Lyman 124gr "Devastator" hollow point
40 S&W - Lee 175gr truncated cone (not the tumble lube version)

These bullets will either be sized and lubed or PC'd and sized. Any start/maximum load recommendations would be greatly appreciated. Also, any loads using an alternate powder such as: Bullseye or 231.

Thanks in advance!

[Walks]

Well, I can give the info from the Lyman Cast Bullet Handbook #4.

40S&W;
Lyman #401098-RNFP & #401638-TC which both weigh 175grs cast of #2 Alloy.

Lists:
Unique - 4.7grs to 5.8grs
Bullseye - 4.0grs to 5.0grs
WW231 - 4.3grs to 5.8grs

.357Sig;

No Listing.

[LRRifleman]

Thank you very much!

I was not aware that a 4th edition had come out.

Ed

[Kirk Miller]

Good morning
In my Sig Sauer two of the three most accurate loads that I have found use two of your listed powders.
All loads use the Lyman 401638 175gr. boolit seated to 1.125"
1. 4gr. bullseye
2. 5.2gr. unique
Hope this helps
Kirk

[Sig556r]

357 Sig CB loads...
http://castpics.net/dpl/index.php/re...et-data-lookup