Does any one know which other brand of bushings will fit the Savage 630. I know that Mec's are too short. Thanks for the info.
Does any one know which other brand of bushings will fit the Savage 630. I know that Mec's are too short. Thanks for the info.
DM,
Thanks,
I'll measure them tonight when I get home. I do know they are of different diameters.
3D printing can rescue presses that use bushings. Even just one for dimensions can be the start. There are already full sets of MEC busing files online.
New member here. I know the OP is long gone but in case anybody else happens to need the bushing dimensions, here they are:
Powder bushing (FWIW, this bushing throws an average weight of 20.5 grains of Red Dot
Flange diameter: .710"
Flange thickness: .060"
Body diameter: .618"
Overall height: .995"
Shot bushing:
Flange diameter: .870"
Flange thickness: .062"
Body diameter: .777"
Overall height: .987"
Dimensions taken from a Savage "M" powder bushing and a 1 1/8 bushing using 0-6" Mitutoyo dial caliper.
Last edited by cp1969; 05-28-2020 at 11:24 PM.
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |