Reloading EverythingLoad DataWidenersMidSouth Shooters Supply
Titan ReloadingLee PrecisionInline FabricationSnyders Jerky
RotoMetals2 Repackbox
Page 2 of 2 FirstFirst 12
Results 21 to 21 of 21

Thread: Plinking load for Garand

  1. #21
    Boolit Buddy
    Join Date
    Dec 2009
    Location
    Just outside New Orleans
    Posts
    405
    I got one of Al 1st run of the old Lyman 311365 200 grain gas checked in brass. 34 grains of 4895 and 35 of Varget was also ,tested by my self and 5 or more others at the CMP Forum they shot well just on par as M2 Ball just lower. So sight had to be adjusted.
    Very accurate loads and great for younger or female shooters or in my case bad shoulder.
    I have some pictures some place. The front lube groove was used as crimp groove. With light crimp. FYI shot better than 165 and 150 Hornady. With cheap eBay copper gas checks and lead from tire shop that was free.
    Last edited by 340six; 09-11-2019 at 11:37 PM.

Page 2 of 2 FirstFirst 12

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Abbreviations used in Reloading

BP Bronze Point IMR Improved Military Rifle PTD Pointed
BR Bench Rest M Magnum RN Round Nose
BT Boat Tail PL Power-Lokt SP Soft Point
C Compressed Charge PR Primer SPCL Soft Point "Core-Lokt"
HP Hollow Point PSPCL Pointed Soft Point "Core Lokt" C.O.L. Cartridge Overall Length
PSP Pointed Soft Point Spz Spitzer Point SBT Spitzer Boat Tail
LRN Lead Round Nose LWC Lead Wad Cutter LSWC Lead Semi Wad Cutter
GC Gas Check