115gr 9mm mold????

[abunaitoo]

Is there anyone who made one????
I find lighter and heaver.
My Camp Carbine likes 115gr jacket.
So I'm thinking a 115gr cast would work just as well.

[Driver man]

I have an old Lee mold that casts a 9mm at 115grains. It is a dual cavity and has the no 90307. This no doesn't show up in any Lee catalogue as 9mm instead it lists it as a 30 cal 230 grain .Ive had this mold for years and produced some accurate loads using 4.1 grains w231

[kevin c]

I found one on the RCBS site, and Accurate Molds has several designs.

[jsizemore]

I'm using the Accurate 35-115Y. It's for HT or PC. I'm doing the HT and there's a bit of a learning curve plus things better be just right with the barrel. Casts great, feeds great

[poppy42]

RCBS. 115 grn round nose. I have one and I like it.

[RED BEAR]

I just sold a lyman 115 gr rn 358072 . Was for 38 and 38super i believe but i used it for 9mm and 38. Just didn't use it much. Keeping ebay but they don't come up often.

[oldhenry]

There was a group buy for a re-run of a MP 9mm 115gr. RN (BB or FB) cast size .359. That GB closed on 3/11/19 & Mihec stated @ closing that he had some over-runs. He is a member of this forum: PM him if interested. I have this mold (8 cav. alum. in BB) & it is a great mold. With 50/50+1.5 they weigh 119.2-119.3. With straight WW they should be close to 115grs.

[Dragonheart]

I use an H&G #115 and #7 for a slightly heaver 9mm. You might take a look at the Saeco #922.

[cwlongshot]

Lyman made one. I had it. Cute lil 115g swc

I still have some cast as I cast about 500 before I sold the mold. Sorry I do not remember the number.

CW

[Burnt Fingers]

Lyman made one. I had it. Cute lil 115g swc

I still have some cast as I cast about 500 before I sold the mold. Sorry I do not remember the number.

CW

358345. I've been bidding on everyone that pops up on eBay.