Got a new Lee ppm this past weekend as my other measure does not care for h4895.
I'm a stickler for measurements and even though in my initial testing of the measure even before I put powder in it I could tell it wasn't zeroed properly. Counting rotations my adjustment rod is a full 3 revolutions off.
The book says 1.0cc will give me 7.1 gr of red dot and when I tested it I had to add .3cc to it so 1.3 would give me 7.1...but it was right on the money so it was repeatable I just had to add .3cc's to whatever charge I wanted.
I can add a spacer to the thimble to account for the 3 threads higher I need the thimble to sit so 1.0cc is actually reading 1.0cc but I'm curious if anybody else ran into this issue. I'm not looking to make a silk purse here but I do want to understand what my volume is at a glance and not have to count # of turns.
So my question is, does your ppm when set to 1.0cc throw what it is supposed to throw or do you have to adjust?