Mihec .410 Full Wadcutter PB/ GC 210gr -Cramer HP and Solid
This one will remain in Group Buy Discussions until we hit 10 commitments. We need 20 to put it into last call. MIHA agreed to run the 434 at 20 molds so this one gets the same treatment.
All the solids will run at the same time as the .434 as they are all cut from the same cherry. Must wait on the HP designs.
MP Molds 410-210-WC Brass plain base Hollow Point or Solid Mold. This is a recreation of the older Lyman full wadcutter designs. It fits the usual 41 caliber revolvers. Offered bullet diameters will be 0.410" which will cast out about a half thousandth larger dependent on your alloy of choice.
Pins included are: For the Hollow Point Mold are 1) Large HP pin, 2) a smaller Penta HP pin, 3) Cup HP pin and 4) Blank pin for a flat nose or in the case you don't want HP pins sticking out the mold.
Sequence of events: Participants order molds and are placed on the list, the Group Buy will close (which will be posted on the thread) at some time determined by MiHec, the molds are made from the orders on the list at the time it is closed or by altering what you want via PM to MiHec after it's closed. Extra molds should be available... order them by PM to MiHec or contacting MP Molds directly . Invoices will be sent out via e-mail from the listed e-mail addresses and you pay by using Paypal...... It is my understanding the invoice will be in Euros which Paypal converts from Euros to dollars dependent on the time that occurs. After you pay, the mold gets shipped.
Post your disguised e-mail address (imashooterATgmailDOTcom), mold choice, number of cavities and the number of molds wanted (one to however many).
Would be available in 2 and 4 Cavity Cramer HP, 4-cav Solid Brass, or 6-cav Solid Aluminum. (Choose PB ONLY)
Features:
- Steel sprue plate
- Hardened steel alignment pins
- Allen keys are included
- RCBS/Lyman top punch is included
- Use MP mold handles or LEE 6 cavity handle (NOT included but you can add for an +$20)
-Sample of sprue lube is included (15ml)
Prices are with shipping included, below.
- 2 Cavity Hollow Point Brass - 95 Euro's (80,75 Euros with discount)
- 4 Cavity Hollow Point Brass - 135 Euros (114,75 Euros with discount)
- 4 Cavity solid Brass 95 Euro's (80,75 Euros with discount)
- 6 Cavity solid Aluminum 95 Euro's (80,75 Euros with discount)
GROUP BUY DISCOUNT OF 15% PERCENT GIVEN AT TIME OF INVOICE
Please list your info in the following way: (user name) (disguised email) (type of mold) (zip code)
Solid Molds:
1)
2)
3)
4)
5)
6)
7)
8)
9)
10)
HP Molds:
1)
2)
3)
4)
5)
6)
7)
8)
9)
10)
|
   
   
|
|
Reply With Quote
