I used a file on the bottom of the handles so mold would sit on factory flat side of handles. Worked fine
Beautiful! Not having a milling machine, and KNOWING it would surely look like the other extreme from "heaven" with my butchering with a file, I hit upon the idea of chucking a piece of 1/2" steel rod in my Rockwell Delta 14" drill press. On to it, I used almost an entire roll of el cheapo Harbor Freight vinyl electric tape to secure my Dremel, which had a carbide burr/mill chucked in it, to it. A 36" yardstick was taped around the rod/Dremel, with it's other end being kept from moving (turning) by the wall .
I fastened my mould handles in a drill press vice, maybe 3/32" above its jaws, using a steel ruler along its edge to insure I was plane. I put a 10 pound weight lifting weight on a wire holding the drill press chuck handle (mine is the 3-prong type) down, and carefully adjusted the depth using the knurled screw for that purpose until it was (technical term, here) almost a smidgeon from the jaw. I started the Dremel -- wearing goggles and holding my breath ) and made an "air" pass; turned the screw to lower the Dremel a hair, and started removing material. I do not recall how many passes I needed to make -- LOTS! -- being disappointed at the time as to how little material was being removed. However -- surprise to me -- it had been -- and my first "test" had the Lee handles fitting the mould, albeit a tad too tight for my liking. I then rubber cemented some 600 grit wet n' dry paper to the drill press table, and remarkably, no less than six or seven passes made for a perfect fit!
Nowhere near professional, I am sure, as a machinist with a mill -- as you showed -- can do; but -- necessity being the mother of invention -- my adaptation worked!
geo
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |