MP-Molds 12ga 525gr WAD Slug Group Buy - Interest Thread

[schemelschelm]

Hi there,

is there any interest for a group buy for this two cavity mold?

Greetz,
schemelschelm

[lar45]

I'd be interested in one. Idahobronco at aol dot com

[Tmaloy]

Missed the opportunity to get one of these so yes I would be interested.

[longbow]

I might consider the full bore version but not interested in the wad slug. I'm guessing though that there is enough difference in diameter that Mihec can't just orbit the cutter like with some rifle and handgun moulds?

If the full bore version is a possibility then consider me interested. If not then no.

Longbow

[rancher1913]

probably should look into the rules first and second there is already a group buy in progress for these in 20, 16, 410. mihec and noe both stock the 12 gauge version.

[longbow]

What rules? And no NOE and Mihec do not have any in stock.

[rancher1913]

for one you need to be a honcho to organize a group buy, so this should be done thru an existing honcho or the op needs to apply to become one first.

last time I looked (admittedly its been awhile) mihec had left overs from a groupbuy, all you had to do was ask him about them.

[jmort]

Anyone can start an interest thread
The MP Honchos are all great to deal with

[longbow]

Yeah, Miha often makes a few extras but normally he is a group buy outfit. Once the extras are gone he doesn't do the stock runs like NOE. Too bad! There's a Mihec mould or two I might be tempted to buy if I didn't have to start a group buy.

NOE did a limited run of the wad slug moulds but so far I haven't seen any re-runs. He may do one if people ask. I do really like the Mihec brass slug moulds though. However, nothing wrong with NOE and they both make double cavity which is really nice.

I haven't run a group buy but didn't realize you had to apply to be a honcho. Makes sense I guess because you are dealing with a significant value of product in a group buy so have to be committed and organized.

Longbow