Got a new .38 Special Lee Loader from Brownells. During initial inspection I noticed that face of the priming chamber has some roughness from machining. At the very center there's a little dimple that leaves a dent to primer. There are also some circular grooves on the face but they seem to imprint very little. After just one priming attempt it's hard to tell though.
As this is a brand new set I guess I could send it back but on the other hand I think smoothing the face might be a way to go. Can the locating ring (that washer in the white) be removed or is it crimped in place? If yes, maybe the high spot could be flattened with proper sized punch?
Thanks in advance.