Last week I cast some 180 TL .311 from an NOE mold that left them pretty fat from quenched WW. Once I dried them in the sun I put some in my usual TL plastic tub and sprayed them with Pam and ran them through a Lee .311 sizer with no problem. Some I put through backwards with thin aluminum plain base GC. I put them in a clean plastic tub with some Dawn and hot tap water, swished them around to clean them, sun dried them again and then tumble lubed in 45-45-10. It sounds like a lot of steps, but the process went smoothly and produced the results I wanted. Just a bit of my retiree time, after all. Were I going to pan lube some Lyman Postel boolits after I ran them through my .460 Lee sizer I got from one of the fine souls here, I'd just do that rather than the final TL. I normally put the filled lube pan in the fridge for 20 minutes or so and push the boolits out from the bottom of the lube sheet. I clean the bases off with mineral spirits before I load them over a card wad atop the BP. GF