Well had a bit of trouble casting these but the mould may have been just hot enough for a start.
Had one big pin in and the penta point in the other.
They came off pretty easy but my spruce cutting/ twisting /Turning over upside down etc was a bit "unco" and I lost the plot after a while.
I think I only cast 20 useable bullets but mostly wrinkly.
I have to sort myself out before, I get every thing hot again and a preheat temp set-up.
The big pin started sticking and I never got it hot again after that.
Ha.
Down the range for a quick play and a bit of a shot.
Using my load for plainbase bullets in the 30-30.
Not bad considering.
Filled deep cavity with wax 50yds.
Deep cavity as cast 50 yards
Penta pin 50 yards.
Good considering just a slip fit into the case and no load development done using rejects.
I think I’m going to like this mould.
Cheers
Wonder what the B.C. Would be?